top of page

WaterJet Micro Cutting

Cutting a wide range of materials, including heat
sensitive ones, with a cutting accuracy of +/-0.01 mm
and a positioning accuracy of +/-0.0025 mm, the
e-dro micro waterjet cutting process occurs by mixing
very fine abrasives and accelerated water at around
800 m/s - 3 times the speed of sound.
Low cutting forces with no thermal impact, make it
possible to cut the most intricate contours, assuring
burrs on the cutting edge are minimal and a high
surface quality equivalent to N7 or Ra 1.6 μm.
Thanks to a waterjet whose diameter is smaller than
0.30 mm, we can provide high cutting speeds and
high quality for sharp and narrow outlines. More
competitive than classic waterjet cutting, EDM or laser;
the micro waterjet cuts plastics, ceramics and
conductive materials with ease.


  • High surface quality : N7 or Ra 1.6 μm

  • No change in material structure

  • No oxidation

  • No thermal impact

  • No tooling cost

  • Minor burrs on the cutting edge

  • Optimal use of material

  • Little to no rework

  • Fast and competitive prototypes

  • Low cutting forces

  • Positioning accuracy (ISO 230-2) : 2.5 μm

  • Cutting repeatability (ISO 230-2) : 2.5 μm

  • Cutting accuracy (depending on material

  • and thickness) : +/- 0.01 mm

  • Maximum piece size : 990 mm x 590 mm

bottom of page